Dans mon ordinateur (fixe) j'ai une carte wifi PCI, de modèle :
Code : Tout sélectionner
Network controller: Qualcomm Atheros AR9485 Wireless Network Adapter (rev 01)
Subsystem: Qualcomm Atheros Device 3118
Kernel driver in use: ath9k
Kernel modules: ath9k
Depuis ce matin, tout d'un coup, on dirait qu'elle ne "voit" plus rien. Elle ne trouve aucun réseau. Ni le réseau domestique Livebox, ni le point d'accès Android de mon smartphone (ces points d'accès étant en revanche bien vus par mon laptop, qui tourne aussi sous Archlinux).
De ce que je comprends, la carte est correctement prise en charge lors du boot:
Code : Tout sélectionner
# dmesg
[...]
[ 2.953525] ath9k 0000:02:00.0: enabling device (0000 -> 0002)
[ 2.957248] ee1004 0-0051: 512 byte EE1004-compliant SPD EEPROM, read-only
[ 2.957760] ee1004 0-0053: 512 byte EE1004-compliant SPD EEPROM, read-only
[ 2.961589] iTCO_vendor_support: vendor-support=0
[ 2.966922] ath: EEPROM regdomain: 0x21
[ 2.966924] ath: EEPROM indicates we should expect a direct regpair map
[ 2.966924] ath: Country alpha2 being used: BB
[ 2.966925] ath: Regpair used: 0x21
[ 2.967259] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[ 2.968169] ieee80211 phy0: Atheros AR9485 Rev:1 mem=0xffffb89a81200000, irq=17
[...]
Code : Tout sélectionner
# ip link show wlan0
2: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN mode DORMANT group default qlen 1000
link/ether 9e:76:33:e7:f2:ba brd ff:ff:ff:ff:ff:ff permaddr 18:a6:f7:d1:9b:20
Code : Tout sélectionner
# iw wlan0 scan
[rien de rien de rien]
Alors à savoir que je ne connais pas grand chose en connexion réseau, et si ça se trouve, je passe à côté de quelque chose d'évident.
Quelqu'un aurait-il une idée ?