Bonjour,
Le enable graphical.target n'a pas de sens.
Oui lightdm est préférable à slim.
Et oui ils ne parlent que des drivers graphiques, il faut bien tous les paquets de base de Xorg
With the default configuration, the Raspberry Pi uses HDMI video if a HDMI monitor is connected. Otherwise, it uses analog TV-Out (also known as composite output or RCA) To turn the HDMI or analog TV-Out on or off, have a look at /opt/vc/bin/tvservice
Use the -s parameter to check the status; the -o parameter to turn the display off and -p parameter to power on HDMI with preferred settings.
Adjustments are likely required to correct proper overscan/underscan and are easily achieved in /boot/config.txt in which many tweaks are set. To fix, simply uncomment the corresponding lines and setup per the commented instructions:
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
overscan_right=8
overscan_top=-16
overscan_bottom=-16
Or simply disable overscan if the TV/monitor has a "fit to screen" option.
disable_overscan=1
Users wishing to use the analog video out should consult this config file which contains options for non-NTSC outputs.
C'est dans le cas ou l'on utilise par exemple HDMI to VGA / HDMI to DVI ?
Je n'arrive pas trop à comprendre à quoi sert graphical.target, bien qu'il ne faille pas l'utiliser
Je n'arrive pas trop à comprendre à quoi sert graphical.target, bien qu'il ne faille pas l'utiliser
le graphiical.target c'est le runlevel 5 cela correspond au mode graphique. Les gestionnaires de connexions, les sessions graphiques sont lancées en ce mode.
Pour connaitre le niveau d'exécution par défaut tu exécutes:
Sur mon raspberry pi cela donne graphical.target. Par contre je ne me souviens plus si j'avais paramétré ceci manuellement ou c'est l'installation de lightdm qui l'a fait automatiquement.