[son alsa pulseaudio]devraient marcher facile mais..(résolu)

[Rolinh]

Bonjour à tous,

ce weekend j'ai installé archlinux+kdemod sur un dell latitude d630. (Presque) tout va bien mais là, je suis obligé de faire appel à vous parce que là ça fait 3h que aujourd'hui (plus un moment hier) que je m'énerve sur deux choses qui persistent à ne pas fonctionner correctement: le son et le wifi.

En fait, ce n'est qu'une question de configuration dans les deux cas.

Pour le son: je ne comprend vraiment pas. Tout marchait mais là... plus rien! Et je ne vois absolument pas pourquoi...
voici ma liste de deamon (et modules):

Code : Tout sélectionner

MODULES=(iwl3945 !snd-pcsp)
DAEMONS=(syslog-ng !network netfs crond alsa dbus hal networkmanager ntpd pulseaudio kdm)

Ma carte son c'est celle-là:

Code : Tout sélectionner

00:1b.0 Audio device: Intel Corporation 82801H (ICH8 Family) HD Audio Controller (rev 02)

J'ai configuré via alsaconf et avec alsamixer j'ai bien vérifier que ce ne soit pas sur mute. En fait, je vois au démarrage que pulseaudio est toujours FAIL donc le problème doit venir de là mais... je ne vois pas...

Désolé de vous inonder avec mes soucis...

Merci d'avance!

[benjarobin]

Peut tu s'il te plait splitter ton message en 2 et faire 2 topics.
Sinon vite fais: pulseaudio -> Il faut donner les logs.
En ne lançant pas networkmanager, et en te connectant en ligne de commande est ce que cela marche ? (voir wiki)

[Rolinh]

C'est fait --> http://forums.archlinux.fr/topic5733.html

pour pulseaudio:

Code : Tout sélectionner

Mar 25 21:08:36 robin-d630 pulseaudio[2075]: main.c: Running in system mode, but --disallow-exit not set!
Mar 25 21:08:36 robin-d630 pulseaudio[2075]: main.c: Running in system mode, but --disallow-module-loading not set!
Mar 25 21:08:36 robin-d630 pulseaudio[2075]: main.c: Running in system mode, forcibly disabling SHM mode!
Mar 25 21:08:36 robin-d630 pulseaudio[2075]: main.c: Running in system mode, forcibly disabling exit idle time!
Mar 25 21:08:36 robin-d630 pulseaudio[2088]: main.c: OK, so you are running PA in system mode. Please note that you most likely shouldn't be doing that.
Mar 25 21:08:36 robin-d630 pulseaudio[2088]: main.c: If you do it nonetheless then it's your own fault if things don't work as expected.
Mar 25 21:08:36 robin-d630 pulseaudio[2088]: main.c: Please read http://pulseaudio.org/wiki/WhatIsWrongWithSystemMode for an explanation why system mode is usually a bad idea.
Mar 25 21:08:36 robin-d630 pulseaudio[2088]: module.c: module-hal-detect is deprecated: Please use module-udev-detect instead of module-hal-detect!
Mar 25 21:08:36 robin-d630 pulseaudio[2088]: module-hal-detect-compat.c: We will now load module-udev-detect. Please make sure to remove module-hal-detect from your configuration.
Mar 25 21:08:37 robin-d630 pulseaudio[2088]: module.c: module-volume-restore is deprecated: Please use module-stream-restore instead of module-volume-restore!
Mar 25 21:08:37 robin-d630 pulseaudio[2088]: module-volume-restore.c: We will now load module-stream-restore. Please make sure to remove module-volume-restore from your configuration.
Mar 25 20:09:28 robin-d630 rtkit-daemon[2869]: Sucessfully made thread 2863 of process 2863 (/usr/bin/pulseaudio) owned by '1000' high priority at nice level -11.
Mar 25 20:09:29 robin-d630 rtkit-daemon[2869]: Sucessfully made thread 2888 of process 2888 (/usr/bin/pulseaudio) owned by '1000' high priority at nice level -11.
Mar 25 20:28:19 robin-d630 rtkit-daemon[2869]: Sucessfully made thread 3210 of process 3210 (/usr/bin/pulseaudio) owned by '1000' high priority at nice level -11.
Mar 25 20:38:35 robin-d630 rtkit-daemon[2869]: Sucessfully made thread 3324 of process 3324 (/usr/bin/pulseaudio) owned by '1000' high priority at nice level -11.
Mar 25 21:56:20 robin-d630 pulseaudio[2134]: main.c: Running in system mode, but --disallow-exit not set!
Mar 25 21:56:20 robin-d630 pulseaudio[2134]: main.c: Running in system mode, but --disallow-module-loading not set!
Mar 25 21:56:20 robin-d630 pulseaudio[2134]: main.c: Running in system mode, forcibly disabling SHM mode!
Mar 25 21:56:20 robin-d630 pulseaudio[2134]: main.c: Running in system mode, forcibly disabling exit idle time!
Mar 25 21:56:20 robin-d630 pulseaudio[2140]: main.c: OK, so you are running PA in system mode. Please note that you most likely shouldn't be doing that.
Mar 25 21:56:20 robin-d630 pulseaudio[2140]: main.c: If you do it nonetheless then it's your own fault if things don't work as expected.
Mar 25 21:56:20 robin-d630 pulseaudio[2140]: main.c: Please read http://pulseaudio.org/wiki/WhatIsWrongWithSystemMode for an explanation why system mode is usually a bad idea.
Mar 25 21:56:20 robin-d630 pulseaudio[2140]: module.c: module-hal-detect is deprecated: Please use module-udev-detect instead of module-hal-detect!
Mar 25 21:56:20 robin-d630 pulseaudio[2140]: module-hal-detect-compat.c: We will now load module-udev-detect. Please make sure to remove module-hal-detect from your configuration.
Mar 25 21:56:21 robin-d630 pulseaudio[2140]: module.c: module-volume-restore is deprecated: Please use module-stream-restore instead of module-volume-restore!
Mar 25 21:56:21 robin-d630 pulseaudio[2140]: module-volume-restore.c: We will now load module-stream-restore. Please make sure to remove module-volume-restore from your configuration.
Mar 25 22:30:05 robin-d630 pulseaudio[2151]: main.c: Running in system mode, but --disallow-exit not set!
Mar 25 22:30:05 robin-d630 pulseaudio[2151]: main.c: Running in system mode, but --disallow-module-loading not set!
Mar 25 22:30:05 robin-d630 pulseaudio[2151]: main.c: Running in system mode, forcibly disabling SHM mode!
Mar 25 22:30:05 robin-d630 pulseaudio[2151]: main.c: Running in system mode, forcibly disabling exit idle time!
Mar 25 22:30:05 robin-d630 pulseaudio[2157]: main.c: OK, so you are running PA in system mode. Please note that you most likely shouldn't be doing that.
Mar 25 22:30:05 robin-d630 pulseaudio[2157]: main.c: If you do it nonetheless then it's your own fault if things don't work as expected.
Mar 25 22:30:05 robin-d630 pulseaudio[2157]: main.c: Please read http://pulseaudio.org/wiki/WhatIsWrongWithSystemMode for an explanation why system mode is usually a bad idea.
Mar 25 22:30:05 robin-d630 pulseaudio[2157]: module.c: module-hal-detect is deprecated: Please use module-udev-detect instead of module-hal-detect!
Mar 25 22:30:05 robin-d630 pulseaudio[2157]: module-hal-detect-compat.c: We will now load module-udev-detect. Please make sure to remove module-hal-detect from your configuration.
Mar 25 22:30:05 robin-d630 pulseaudio[2157]: module.c: module-volume-restore is deprecated: Please use module-stream-restore instead of module-volume-restore!
Mar 25 22:30:05 robin-d630 pulseaudio[2157]: module-volume-restore.c: We will now load module-stream-restore. Please make sure to remove module-volume-restore from your configuration.
Mar 25 22:48:40 robin-d630 pulseaudio[4412]: main.c: Running in system mode, but --disallow-exit not set!
Mar 25 22:48:40 robin-d630 pulseaudio[4412]: main.c: Running in system mode, but --disallow-module-loading not set!
Mar 25 22:48:40 robin-d630 pulseaudio[4412]: main.c: Running in system mode, forcibly disabling SHM mode!
Mar 25 22:48:40 robin-d630 pulseaudio[4412]: main.c: Running in system mode, forcibly disabling exit idle time!
Mar 25 22:48:40 robin-d630 pulseaudio[4420]: main.c: OK, so you are running PA in system mode. Please note that you most likely shouldn't be doing that.
Mar 25 22:48:40 robin-d630 pulseaudio[4420]: main.c: If you do it nonetheless then it's your own fault if things don't work as expected.
Mar 25 22:48:40 robin-d630 pulseaudio[4420]: main.c: Please read http://pulseaudio.org/wiki/WhatIsWrongWithSystemMode for an explanation why system mode is usually a bad idea.
Mar 25 22:48:40 robin-d630 pulseaudio[4420]: module.c: module-hal-detect is deprecated: Please use module-udev-detect instead of module-hal-detect!
Mar 25 22:48:40 robin-d630 pulseaudio[4420]: module-hal-detect-compat.c: We will now load module-udev-detect. Please make sure to remove module-hal-detect from your configuration.
Mar 25 22:48:40 robin-d630 pulseaudio[4420]: module.c: module-volume-restore is deprecated: Please use module-stream-restore instead of module-volume-restore!
Mar 25 22:48:40 robin-d630 pulseaudio[4420]: module-volume-restore.c: We will now load module-stream-restore. Please make sure to remove module-volume-restore from your configuration.

Sinon, mon .asoundrc:

Code : Tout sélectionner

pcm.!default {
type hw
card 1
}
ctl.!default {
type hw 
card 1
}

et mon asound.conf

Code : Tout sélectionner

pcm.pulse {
    type pulse
}
ctl.pulse {
    type pulse
}
pcm.!default {
    type pulse
}
ctl.!default {
    type pulse
}

pcm.pulse_monitor {
  type pulse
  device alsa_output.pci-0000_00_1b.0.analog-stereo.monitor
}

ctl.pulse_monitor {
  type pulse
  device alsa_output.pci-0000_00_1b.0.analog-stereo.monitor
}

pcm.phononpulse {
  type plug
  slave.pcm {
    type pulse
  }
  hint {
    show on
    description "PulseAudio"
  }
}

Ca peut aider?

[Nydol]

Quelques questions :
1 - As-tu essayé d'utiliser ALSA seul (sans PA) ?
2 - As-tu suivis le wiki anglophone ? http://wiki.archlinux.org/index.php/Pulseaudio
3 - As-tu réellement besoin de PA ?

Sinon tu lances pulseaudio en root, c'est apparemment une mauvaise idée, mais je pense pas que ce soit le problème.

[chipster]

pulseaudio est en perte de vitesse et n'apporte rien à par des complication. Autant installer OSSv4 qui fait la même chose mais en mieux

[Rolinh]

Merci pour vos réponse
Je n'ai plus qu'alsa mais au moins, j'ai le son!